Go Back   OhioFlyers.org > Technical Support

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-13-2017, 01:14 PM
freeeba freeeba is offline
Club Member
Join Date: Feb 2009
Location: USA
Posts: 432
Thanks: 88
Thanked 92 Times in 57 Posts
Default Dangler's winch device project

Those interested :

Build TOTALLY EFFICIENT, continuously controllable devise to connect and subject a 2500 lb. rolling brushcutter to vertical rise and descent with a forward/reverse MINIMUM working speed of 10 feet in four seconds for normal operations and 35-MPH for bottom to top return on a 80 degree angle over eight inch negative and positive obstruction.


*Rope cable to be AmSteel Blue 12-strand. A braided rope w/Samthane coating and Dyneem SK-75 fiber. Size : 1/2" X 300' plus rap around drum. This unit cannot fail. Rope cannot fail. Brake must hold every time. Must continuously FLAT rewind rope at ANY angle of winch deck with reversing directions and speed going on.

Mounting :

Can be mounted on the main ZT drive unit. Forward of engine or from rear frame member with a pivot to vertical. ZT drive unit is 20" wide at rear frame made of multi. 1" X 2" rec. tube. Keep winch platform as short and strong as possible but width can be up to four feet if needed.

If Stationary unit is your desire include power source, remote control to a foot pedal on ZT drive. Hook-up to 2" Reese receiver.

Winch Drive : Can be hydraulic, mechanical or electric.

Last edited by freeeba; 02-21-2017 at 02:11 PM.
Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -5. The time now is 01:42 PM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.

Skin design by bogu@project-voyageur